Race Car Cardboard Construction Template Makedo and I-Create Compatible

This Race Car laser cut cardboard construction template is compatible with the cardboard construction systems from Makedo and I-Create (Available from Bunnings) screws and tools.

It includes SPINNING wheels. Tiny Science Lab has created clever 3d printed hubs to allow wheels to spin when using Makedo or I-Create Screws.

Not only can the kids make the car, they can then go onto playing with it as well. Vroom vroom!

Our yellow 3d printed hubs push into the top of the screws allowing our wheels to spin freely.

This Race Car is suitable for ages 7 and up.

It requires a total of 18 screws to construct it.

Instructions:

We recommend colouring the car with crayons or painting it prior to it being built.

1. Poke out all the screw holes.

2. Push out each piece of the race car as required.

3. Fold the sides of the bonnet, roof and rear bumper using a ruler as a straight edge.

4. Screw each side of the car into place.

5. Place each of the wheels onto a yellow hub and push them into the wheel screws

6. Have fun playing with the car!

Included in this set:

1. A Race Car cardboard template - 53cm long by 26cm wide.

2. 4 x yellow 3d printed wheel hubs.

Note: Tools and Screws NOT included.

Upon purchase you will receive an email link to download an instruction sheet.